Agar 3D Gloss - Floor Finish
3D-GLOSS is a super-glossy polish for vinyl, timber and stone floors. It is designed with a fast cure rate for use in supermarkets where it buffs up easily under UHS buffing machines to provide a crystal-clear, dazzling gloss.
Benefits
- Floors will sparkle when sealed with 3D-GLOSS.
- 3D-GLOSS is non-slip.
- Stays shiny for longer because of its high scratch repair
- Responds to both gas and electric buffing machines.
- Excellent for supermarkets and other busy floors.
For Use On
Vinyl tiles, Sealed timber, Sealed terrazzo, Sealed marble, Terracotta, Slate, Linoleum, and Brick floors
Specifications
Colour: Milky white liquid
Odour: Faint ammonia odour
pH Level: 8.4 - 9.4
Sealer Type: Top Coat
Coverage: 45 - 55 m2
Available in the following options
Size
Directions For Use
- Remove adhesive, built-up polish or wax and other soilage using ULTRASTRIP, DEMOLISH or STR-36. New floors should always be stripped prior to sealing. Whilst a new floor looks clean, it is covered in a protective film added at the time of manufacture. New floor polish will not adhere to this film, so it must be stripped.
- Flood-rinse floor to remove the stripper and dirt. The floor must be well covered in clean water. Mop up or wet-vac and allow to dry. If floor is vinyl, burnish floor then fringe mop to remove dust. Do not burnish bare terrazzo or stone floors.
- Apply basecoat polish using a fringemop or bucket mop. On vinyl tile floors that take heavy traffic, 2 coats of MASTERPIECE are recommended. On terrazzo, marble and polished concrete, one coat of FIRST BASE must be applied to seal the floor. Check that the basecoat/s are tack-free and dry before applying 2 or 3 coats of 3DGLOSS, making a total of 4 coats.
- After 2 to 7 days, apply 2 more coats of 3D-GLOSS. This film of 6 coats will provide a sound foundation for protecting the flooring and will give an excellent depth of shine.
- For the first week, soft buffing pads (such as champagne) must be used. After this period, Jackeroo Lite or other UHS pads can then be used for burnishing.
- Maintain floor by cleaning with AUTOSCRUB, SYMPOL or SCRUB ‘N’ SHINE then dry buffing or spray buffing. Softer pads with no natural hair-fibres are preferred.
- Re-coat heavy traffic areas when required. This will ensure a shiny, beautiful and long-wearing coating.
- Worn films may be scrubbed off using FLORPREP at 1:20 with blue pads and may then be recoated with 3DGLOSS after buffing and sweeping.
- Do not apply any polish to a very cold floor (9ºC or less). If application is unavoidable in very cold or humid weather, lay very thin coats one hour apart.
Accessories
Chemical dispensing accessories
Downloads
