Agar Ultrastrip - Polish remover

ULTRASTRIP is a powerful stripper that rips through old films of hardened floor polish and rinses away easily leaving old floors stripped clean and ready for recoating.

Benefits

• Odourless
• Easy to rinse
• Complete stripping action, even on stubborn coatings
• Rips through old polish and heavy build-ups
• Floors are not slippery to walk on when ULTRASTRIP is in use

For Use On

ULTRASTRIP will not affect metal, vinyl tile or wood surfaces but must be diluted for stripping rubber floors. It should be well diluted and used cautiously on sheet vinyl floors.

Specifications

Colour: Transparent, colourless liquid

Odour: Mild odour

pH Level: 11.5 - 14.0

Foam: Low foaming

Available in the following options

Size

• 5L
• 20L (Special Order)

Directions For Use

Choose the correct dilution rate from the table below then make up the ULTRASTRIP solution with cold water.

• Dilute 1 part of ULTRASTRIP with from 10 to 20 parts of cold water. For severe polish build-ups higher concentrations up to 1 in 3 ULTRASTRIP may be used, but for rubber or sheet vinyl floors it MUST be diluted to at least 1 in 20 with water.
• Mop ULTRASTRIP solution generously over the floor and allow 10 to 15 minutes to activate. Keep the floor wet with solution; don’t let it dry out (apply more if necessary).
• Scrub floor with a black pad under a slow machine, spending more time along the edges where the sealer will be thickest.
• Mop up solution and rinse floor with clean hot water.
• Floors that are porous should be flood-rinsed i.e., should be completely covered with clean hot water and then wet-vacuumed or mopped up. This is needed to remove the stripper from all of the pores in the floor.

Accessories

Chemical dispensing accessories

Downloads

Product Information Sheet

Safety Data Sheet